BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 325

Insert grommet no. 14 in dashboard hole and pull
it from inside bilge.
NOTE: To ease installation, apply water on grom-
met.
Insert wires of monitoring beeper and start/stop
button.
Insert spring washer no. 15 and the shim no. 16
onto steering stem no. 17.
Insert steering stem into support no. 18.
1
3
F02K05A
1. Steering stem
2. Grommet
3. Spring washer
4. Shim
Properly position steering stem arm no. 10 on
steering stem. Make sure to insert stem tenon
into arm mortise.
Apply Loctite 271 (red) on threads of screw
no. 13.
Install large flat washer no. 19, lock washer
no. 20 and screw no. 13. Torque screw to 40
N•m (30 Ibf•ft).
-
CAUTION
Always install large flat washer with the X
stamped side facing the lock washer.
WARNING
The recommended torque and Loctite must
be applied on screw. Steering arm mortise
must seat properly on steering stem tenon.
2
4
Section 10 STEERING SYSTEM
Subsection 03 (GTS MODEL)
2
5
6
F01K0VA
TYPICAL
1. Steering stem tenon
2. Steering stem arm
3. Mortise
4. Large flat washer with X
5. Lock washer
6. Screw, apply Loctite 271 and torque to 40 N•m (30 Ibf•ft)
Position 8 mm flat washer no. 12 on steering
stopper screw then install locking plate no. 9 over
steering stem head screw.
NOTE: Ensure locking plate slot is inserted in
steering stopper screw.
Install a second 8 mm flat washer no. 12 and se-
cure locking plate using jam nut no. 11. Torque
nut to 7 N•m (62 Ibf•in).
3
F01K10A
STEERING CABLE NOT SHOWN FOR MORE CLARITY
1. Steering stem head screw
2. Locking plate
3. Steering stopper screw
4. 8 mm flat washers
5. Torque nut to 7 N•m (62 lbf•in)
1
3
4
1
2
5
4
10-03-3