BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 148

Push cone no. 5 until it touches tuned pipe, then
tighten exhaust clamp no. 4 and torque to 10 N•m
(88 lbf•in).
-
CAUTION
There must be no gap between tuned pipe
cone and tuned pipe head.
NOTE: Exhaust clamp nuts should be tightened
alternately to assure no leakage and to obtain
specified torque.
947 Engine
Torquing Sequence
Torque Allen screws no. 7 at tuned pipe head
flange to 25 N•m (18 lbf•ft).
NOTE: Torque nut no. 8 only to 18 N•m (13 lbf•ft)
using the polygonal key (P/N 529 035 505).
F06D1TA
1. Torque Allen screws and nut to 25 N•m (18 lbf•ft)
Subsection 08 (EXHAUST SYSTEM)
Torque bolt of tuned pipe head above the engine
magneto to 25 N•m (18 lbf•ft).
F06D1UA
1. Torque bolt to 25 N•m (18 lbf•ft)
Torque bolt of tuned pipe cone beside the engine
water return hose to 25 N•m (18 lbf•ft).
1
F06D1VA
1. Torque bolt to 25 N•m (18 lbf•ft)
Section 04 ENGINE
1
1
04-08-11