BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 66

Magneto flywheel is easily freed from crankshaft
with puller (P/N 295 000 106).
A00C1AA
Fully thread on puller in puller plate.
Tighten puller bolt and at the same time, tap on
bolt head using a hammer to release magneto fly-
wheel from its taper.
1
2
F01D4CA
1. Puller plate
2. Puller
3. Extension handle
10, Armature Plate
Remove 3 retaining screws no. 15 and withdraw
armature plate.
7, Magneto Housing
To remove magneto housing, starter has to be re-
moved. Refer to STARTING SYSTEM 08-04.
Unscrew retaining screws no. 9, then withdraw
housing.
4,5, Magneto Flywheel and Ring Gear
Lay magneto flywheel on a steel plate. Tap lightly
on ring gear using a hammer to release it from
magneto flywheel.
1
F01D3AA
1. Magneto flywheel
11, Generating Coil
To replace generating coil:
– Heat the armature plate to 93°C (200°F) around
the screw holes to break the threadlocker
bond.
3
F00D08A
1. Heat the armature plate
Protect harness from flame.
– Remove screws.
– Uncrimp and unsolder BLACK/RED wire from
coil.
Section 04 ENGINE
Subsection 04 (MAGNETO SYSTEM)
-
CAUTION
1
04-04-5