BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 401

Section 14 WIRING DIAGRAMS
Subsection 01 (WIRING DIAGRAMS)
Removal
To remove the plug connector from the header as-
sembly, press both tabs and pull plug.
1
2
F00H0NA
1
Step : Press tabs (both sides)
2
Step : Pull plug
Installation
Apply a thin coat of DEOXIT contact lubricant (P/N
293 550 015) to the pins of the header on the
MPEM only.
F00H11A
1. Apply a thin coat of DEOXIT contact lubricant
-
CAUTION
Do not apply lubricant excessively. Care
must be taken so that the lubricant will not
come in contact with the mating seal; the
seal may loose its sealing capacities. Do not
apply lubricant on contacts inside plug con-
nector.
14-01-2
1
Each plug assembly is mechanically keyed to
mate only with identical mechanical keyed header
on the MPEM.
1
F00H12A
1. Mechanically keyed
Contact Removal
SIGNAL WIRE
Insert a screwdriver blade between the connector
and the wedge lock tab.
Release the locking tab and at the same time, pry
open the wedge lock to open position.
-
CAUTION
The wedge lock should never be removed
from the connector for insertion or removal
of the signal wire contacts