Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 769

APPENDIX
(2) Writing the parameter
The following shows a program example when two stations are occupied.
Change parameter No.PC12 (JOG speed) of the servo amplifier of station 2 to "100".
The parameter group PC is specified as follows.
Code No.
8200h
Set data
H0002
The parameter No.12 is changed to "100" as follows.
Code No.
H820C
Set data
K100
Write the data to the parameter No.PC12 by turning on X20.
The respond code at instruction code execution is set to D2.
Write command
Description
Parameter group selection
Description
Set data (hexadecimal)
Description
Parameter No.PC12 write (hexadecimal)
Description
Set data (decimal)
App. - 14
Reads remote input (RX20 to RX5F) of buffer
memory to M200 to M263.
Writes parameter group No. write (H8200) to
RWw6 and parameter group PC (H0002) to
RWw7.
Turns on instruction code execution demand
(RY29).
Turns off instruction code execution demand
(RY29) when instruction code execution
completion (RX29) turns on.
Writes parameter No.PC12 write (H820C) to
RWw6 and data (K100) to RWw7.
Turns on instruction code execution demand
(RY29).
Reads RWw6 to D2 when instruction code
execution completion (RX29) turns on.
Turns on instruction code execution demand
(RY29).
Writes M100 to M163 to remote output (RY20 to
RY5F) of buffer memory.