Parameter - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

17. SPEED CONTROL OPERATION

17.8 Parameter

CAUTION
In this servo amplifier, the parameters are classified into the following groups on a function basis.
Mainly setting the basic setting parameters (No.PA
introduction.
Never make a drastic adjustment or change to the parameter values as
doing so will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these
values.
Do not change parameters for manufacturer setting.
Do not set values other than described setting values to each parameter.
POINT
To enable a parameter whose symbol is preceded by *, cycle the power after
setting it.
Parameter group
Basic setting parameters
(No.PA )
Gain/filter parameters
(No.PB )
Extension setting parameters
(No.PC )
I/O setting parameters
(No.PD )
Main description
Make basic settings with these parameters. Generally, the operation is
possible only with these parameter settings.
Use these parameters when making gain adjustment manually.
This parameter group is unique to MR-J3- T servo amplifier.
Use these parameters for setting how to stop the stroke end (LSP and
LSN), etc.
) allows the setting of the basic parameters at the time of
17 - 36