Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 139

4. SIGNALS AND WIRING
(b) Termination of the cables
Solid wire: After the insulator has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the insulator and twisting the core. At this time, take care to
avoid a short caused by the loose wires of the core and the adjacent pole. Do not solder the
core as it may cause a contact fault. Alternatively, a bar terminal may be used to put the wires
together.
c) The twin type connector for CNP2 (L
Using this connector enables passing a wire of control circuit power supply.
Refer to appendix 2 for details of connector.
(3) MR-J3-350T
(a) Servo amplifier power supply connectors
Servo amplifier power supply connectors
Applicable cable example
Cable finish OD: to
Applicable cable example
Cable finish OD: to
Insulator
Cable size
2
[mm ] AWG
1.25/1.5 16
2 14
Note 1. Manufacturer: Phoenix Contact
2. Manufacturer: WAGO
L
11 21
L
11
Power supply
or Front axis
L
21
PC4/6-STF-7.62-CRWH
5mm
PC4/3-STF-7.62-CRWH
3.8mm
Core
8mm to 9mm
Bar terminal type
For 1 cable
AI1.5-10BK AI-TWIN2
(Note 1)
216-205 (Note 2)
): 721-2105/026-000 (WAGO)
Twin type connector for CNP2
CNP2
L
11
Rear axis
L
21
Connector for CNP1
(Phoenix Contact)
Connector for CNP3
(Phoenix Contact)
Connector for CNP2
54928-0520 (Molex)
4 - 18
Crimping tool (Note 2)
For 2 cable
1.5-10BK
(Note 1) Variocrimp 4 206-204
Servo amplifier
CNP1
CNP3
CNP2