Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 654

16. INDEXER POSITIONING OPERATION
No. Symbol
PD15 For manufacturer setting
Do not change this value by any means.
PD16 *DIAB Input polarity selection
Used to set the proximity dog input polarity. (Refer to section 5.6.)
0 0
PD17 For manufacturer setting
Do not change this value by any means.
PD18
PD19 *DIF Response level setting
Used to select the input.
0 0 0
PD20 *DOP1 Function selection D-1
Select the stop processing at forward rotation stroke end (LSN)/reverse rotation
stroke end (LSN) OFF and the base circuit status at reset (RY(n 1)A or
RY(n 3)A) ON.
0 0
PD21 For manufacturer setting
Do not change this value by any means.
PD22 Not used in indexer positioning operation.
Do not change the parameter.
PD23 For manufacturer setting
Do not change this value by any means.
Name and function
0
Proximity dog input polarity
0: OFF indicates detection of the dog
1: ON indicates detection of the dog
Input filter
If external input signal causes chattering due
to noise, etc., input filter is used to suppress it.
0: None
1: 0.888[ms]
2: 1.777[ms]
3: 2.660[ms]
4: 3.555[ms]
5: 4.444[ms]
Stopping method for Forward rotation stroke end (LSP)
off or Reverse rotation stroke end (LSN) off
0: Sudden stop (home position erased)
1: Slow stop (home position erased)
2: Slow stop (Setting contents is the same as for "1".)
3: Sudden stop (Setting contents is the same as for "0".)
Even in this case, when LSP or LSN is detected, home
position return is required again before executing automatic
operation. However, in the absolute position detection
system (parameter No.PA03:
return completion (ZP) can be turned on by turning on the
servo-on. In the case, executing another home position.
Selection of base circuit status at reset (RY(n+1)A or
RY(n+3)A)ON
0: Base circuit not switched off
1: Base circuit switched off
1), the home position
16 - 99
Initial
Unit Setting range
value
0000h
0000h Refer to
name and
function
column.
0000h
0000h
0002h Refer to
name and
function
column.
0010h Refer to
name and
function
column.
0000h
0000h
0000h