Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 650

16. INDEXER POSITIONING OPERATION
No. Symbol
PC46 *STN Indexer positioning operation number of stations/rotation
Set the number of stations (dividing number) per machine rotation. When
the setting value is 2 or lower, the number of stations is set to 2.
PC47 PSST Indexer positioning operation station home position shift distance
This parameter is available only in the absolute position detection system.
Set the distance for shifting the home position toward the set home
position in number of pulses.
This shift distance does not become valid immediately after the home
position setting. It becomes valid after turning off and then on the power.
When the sift distance is larger than the in-position range, the in position
(RXn1) does not turn on at power-on.
Set the number of pulses to be shifted after converting it into hexadecimal.
The setting range is from
PC48 For manufacturer setting
PC49 Do not change this value by any means.
PC50 *COPA Function selection C-A
0 0 0
This parameter is available with servo amplifiers with software version A8
or later.
When this parameter is set using MR Configurator with software version
C5 or earlier, the parameter name is not displayed. However, the setting
value is changeable. Follow the instructions in this Instruction Manual to
set the value.
Name and function
Number of
Setting value
stations
0000 2
0001 2
0002 2
0003 3
0004 4
00FF 255
2000 to 2000 pulse.
CC-Link communication error (A8D)
extended function selection
0: No extended function
1: CC-Link communication error (A8D) detection delay
Use parameter No.PD25 to set how long to delay the
occurrence timing of CC-Link communication error (A8D).
16 - 95
Initial value Unit Setting range
0000h Number of
stations
0000h pulse
name and
0000h
0000h
0000h Refer to the
Name and
0000h
to
00FFh
Refer to
function
column
function
column.