Suzuki VLR1800 Service Manual page 548

5B-16 Manual Transmission:
6) Remove the gearshift shaft assembly (5) and
washers (6).
6
5
7) Remove the following parts from the gearshift shaft
(7).
• Snap ring (8)
• Gearshift return spring (9)
• Gearshift cam drive plate (10)
• Plate return spring (11)
• Washer (12)
Special tool
: 09900–06107 (Snap ring pliers)
8
10
11
8) Remove the gearshift cam plate bolt (13) and
gearshift cam plate (14).
9) Remove the gearshift cam stopper (15).
13
I822H1520052-02
9
7
8
12
I822H1520053-02
14
15
I822H1520054-01
10) Remove the gearshift arm stopper (16).
16
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
CAUTION
!
The removed snap rings must be replaced
with the new ones.
• Apply a small quantity of thread lock to the gearshift
arm stopper (1) and tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (a): 19 N·m (1.9 kgf-m, 13.5
lb-ft)
1
• Install the gearshift cam stopper (2), bolt (3), washer
(4) and return spring (5).
I822H1520055-01
(a)
I822H1520056-02