IN.
EX.
9) Remove the secondary gear case cover. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-3)".
10) Remove the generator cover cap (3) and valve
timing inspection plug (4).
11) Remove the generator cover cap (5).
"B"
EX.
"A"
IN.
I822H1020021-03
4
3
I822H1020015-01
5
I822H1020016-01
Maintenance and Lubrication:
12) Turn the crankshaft to set the #1 (Rear) cylinder at
TDC of compression stroke. (Align the "R | T" line on
the generator rotor to the center of valve timing
inspection hole and also bring the camshafts to the
position "B" as shown.
IN.
13) To inspect the #1 (Rear) cylinder tappet clearance,
use a thickness gauge between the tappet and the
cam. If the clearance is out of specification, adjust it
into the specified range.
Special tool
(A): 09900–20803 (Thickness gauge)
0B-6
R T
I822H1020017-01
"B"
EX.
I822H1020022-01
(A)
I822H1020019-01