Suzuki VLR1800 Service Manual page 430

2C-9 Rear Suspension:
Cushion rod
Remove the cushion rod bearings using the special
tools.
Special tool
(A): 09921–20240 (Bearing remover set)
Installation
CAUTION
!
The removed bearings and cushion seals
must be replaced with new ones.
Cushion lever
1) Press the bearings into the cushion lever with the
special tool and suitable socket wrench as shown in
the rear suspension assembly construction. Refer to
"Rear Suspension Assembly Construction (Page 2C-
2)".
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84521 (Bearing installer set)
2) Install the cushion lever seal with the special tool.
(A)
3) Apply grease to the bearings and cushion lever
I822H1230015-01
Cushion rod
1) Press the bearings into the cushion rod with the
(A)
I822H1230016-01
Special tool
(B): 09913–70210 (Bearing installer set)
seals.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84521 (Bearing installer set)
(A)
(B)
I822H1230017-01
I822H1230018-01
I822H1230019-01