8) Loosen the swingarm pivot shaft clamp bolt (3) and
remove the swingarm pivot shaft (4) with the special
tool.
Special tool
(A): 09944–28320 (Hexagon socket (19
mm))
9) Remove the cushion rods (5).
5
10) Remove the cushion lever (6).
6
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily tighten the cushion lever upper nut (1)
3
4
(A)
• Install the washer and swingarm pivot shaft.
I822H1230024-01
• Tighten the swingarm pivot shaft (3) to the specified
• Tighten the swingarm pivot shaft clamp bolt (4).
I822H1230025-01
I822H1230026-01
and cushion lever lower nut (2).
torque with the special tool.
Special tool
(A): 09944–28320 (Hexagon socket (19 mm))
Tightening torque
Swingarm pivot shaft (a): 100 N·m (10.0 kgf-m,
72.5 lb-ft)
3
(a)
(A)
Rear Suspension:
2C-6
2
1
I822H1230027-02
4
I822H1230030-03