Suzuki VLR1800 Service Manual page 465

3) Install the driven gear stopper with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
NOTE
The chamfer side "A" of the driven gear
stopper faces to the bearing.
4) Install the oil seal with the special tool.
CAUTION
!
The removed oil seal must be replaced with a
new one.
Special tool
(A): 09913–70210 (Bearing installer set)
5) Apply grease to the lip of the oil seal.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(A)
"A"
I822H1310017-01
(A)
I822H1310018-01
I822H1310019-02
Drive Chain / Drive Train / Drive Shaft:
6) Install the secondary bevel gear (1).
NOTE
When install the secondary driven gear, fit
the convex parts "A" of the secondary driven
gear onto the concave parts "B" of the output
cam dog.
1
"B"
7) Install the bearing housing (2) and tighten the
bearing stopper (3) to the specified torque with the
special tool.
CAUTION
!
Replace the bearing stopper (3) with a new
one.
Special tool
(B): 09924–41830 (Bearing retainer wrench)
Tightening torque
Secondary driven bevel gear bearing stopper
(a): 105 N·m (10.5 kgf-m, 76.0 lb-ft)
2
"A"
I822H1310023-01
3
(a)
I822H1310024-01
3A-7