Suzuki VLR1800 Service Manual page 286

1D-75 Engine Mechanical:
• Tighten the water inlet pipe mounting bolts.
CAUTION
!
Apply thread lock to the bolt "C".
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Oil Pressure Switch
• Apply bond to the thread part of the oil pressure
switch (1) and tighten the oil pressure switch (1) to the
specified torque.
NOTE
Be careful not to apply bond to the hole of
thread end.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
"C"
I822H1140240-01
1
(a)
I822H1140241-01
Oil Cooler
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
NOTE
When install the oil cooler, fit the convex part
"A" of the lower crankcase onto the concave
part "B" of the oil cooler.
"B"
• Connect the water hose (1).
• Tighten the union bolt to the specified torque.
Tightening torque
Oil cooler union bolt (a): 70 N·m (7.0 kgf-m, 50.5
lb-ft)
(a)
"A"
I822H1140242-01
1
I822H1140243-01