Suzuki VLR1800 Service Manual page 475

17) Remove the final driven bevel gear bearing (15) from
the bevel gear with two bolts or suitable bars.
NOTE
If no abnormal noise, the bearing removal is
not necessary.
15
18) Remove the oil seal (16) with the special tool.
Special tool
(E): 09913–50121 (Oil seal remover)
(E)
19) Remove the final driven gear bearing (16) and oil
seal (17) with the special tools.
Special tool
(F): 09941–64511 (Bearing remover)
(G): 09930–30104 (Rotor remover slide
shaft)
16
(F)
(G)
I822H1310061-01
16
I822H1310062-01
17
(F)
(G)
I822H1310063-01
Drive Chain / Drive Train / Drive Shaft:
20) Remove the final drive gear bearing (19) with the
special tools.
Special tool
(H): 09923–74511 (Bearing remover)
(G): 09930–30104 (Rotor remover slide
shaft)
21) Remove the oil seal (20) and O-ring (21) from the
bearing stopper.
Assembly
Reassemble the final gear case in the reverse order of
disassembly. Pay attention to the following points:
• Install a oil seal (1) and O-ring (2) to the bearing
stopper.
NOTE
The removed oil seal (1) and O-ring (2) must
be replaced with new ones.
3A-17
19
(H)
(G)
I822H1310064-01
20
21
I822H1310065-01
1
2
I822H1310066-01