Suzuki VLR1800 Service Manual page 304

1D-93 Engine Mechanical:
4) Turn the balancer driven gear No. 1 (3).
5) Align the balancer driven gear No. 1 (3) with the hole
of the balancer driven gear No. 2.
3
6) Install the spring washers (4) and spacers (5).
7) Apply a small quantity of thread lock to the balancer
driven gear bolts and tighten its to the specified
torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Balancer driven gear bolt (M6) (a): 10 N·m (1.0
kgf-m, 7.0 lb-ft)
Balancer driven gear bolt (M8) (b): 25 N·m (2.5
kgf-m, 18.0 lb-ft)
5
4
5
(a)
(b)
(A)
I822H1140316-01
5
4
5
I822H1140317-02
(b)
(a)
I822H1140318-01
8) Remove the balancer driven gear assembly from the
special tool.
9) Set the balancer shaft so that its slit "A" is aligned
with the punch mark "B" on to the balancer driven
gear.
10) Install the balancer driven gear assembly onto the
balancer shaft with the special tool.
Special tool
(B): 09940–51710 (Bearing installer)
"B"
"A"
I822H1140319-01
(B)
I822H1140320-01