Suzuki VLR1800 Service Manual page 541

Driveshaft
• Remove the bearing (1), washer (2) and 1st driven
gear (3).
3
1
• Remove the 1st driven gear bushing (4), washer (5)
and 5th driven gear (6).
6
5
4
• Remove the snap ring (7), washer (8) and 4th driven
gear (9).
9
8
7
• Remove the 4th driven gear bushing (10), washer
(11), snap ring (12) and 3rd driven gear (13).
11
10
2
I822H1520027-01
I822H1520028-01
I822H1520029-01
13
12
I822H1520030-01
• Remove the snap ring (14), washer (15), 2nd driven
gear (16) and its bushing.
14
• Remove the bearing (17) from the secondary drive
gear (18) with the commercially available bearing
remover and special tool.
Special tool
: 09913–70210 (Bearing installer set)
18
NOTE
• Rotate the bearing by hand to inspect if
there are any abnormal noises and smooth
rotation. Replace the bearing if there is
anything unusual.
• Before installing the gears, apply engine
oil to the driveshaft and countershaft.
• Before installing the oil seal, apply grease
to the oil seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Manual Transmission:
16
15
I822H1520031-01
(A)
17
I822H1520032-01
5B-9