Suzuki VLR1800 Service Manual page 282

1D-71 Engine Mechanical:
Crankcase
• Apply grease to the O-rings.
CAUTION
!
Use the new O-rings to prevent oil pressure
leak.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the dowel pins and O-rings in the upper
crankcase.
"A": Apply bond to both surfaces of the upper and lower cases.
• Match the upper and lower crankcases.
NOTE
Align the gearshift forks "A" with each
gearshift groove "B".
I822H1140227-01
"A"
• Apply bond to the mating surface of the lower
crankcase.
NOTE
• Make surfaces free from moisture, oil, dust
and other foreign materials.
• Spread on surfaces thinly to form an even
layer, and assemble the crankcases within
few minutes.
• Take extreme care not to apply any bond to
the oil hole, oil groove and bearing.
• Apply to distorted surfaces as it forms a
comparatively thick film.
• Apply sealant to both mating surface of
crankcases at hatched parts.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
: Apply bond.
"B"
I822H1140355-02
"A"
I822H1140228-01