Rear Wheel Dust Seal / Bearing Removal And Installation - Suzuki VLR1800 Service Manual

2D-14 Wheels and Tires:
Rear Wheel Dust Seal / Bearing Removal and
Installation
Removal
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation
(Page 2D-11)".
2) Remove the dust seal (1).
Special tool
(A): 09913–50121 (Oil seal remover)
1
3) Remove the bearings (2) on both sides using the
special tool.
Special tool
(B): 09921–20240 (Bearing remover set)
2
4) Remove the spacer (3).
B822H12406010
(A)
I822H1240024-01
(B)
I822H1240025-01
3
I822H1240026-01
Installation
CAUTION
!
The removed dust seals and bearings must
be replaced with new ones.
1) Apply grease to the wheel bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
2) First install the right wheel bearing, then install the
spacer (1) and left wheel bearings with the special
tools.
Special tool
(A): 09941–34513 (Steering race installer)
(B): 09924–84510 (Bearing installer set)
CAUTION
!
The sealed cover of the bearing must face
outside.
I649G1240019-02
(A)
(B)
I822H1240027-02