Ping; Show Users - Enterasys SecureStack C2 C2G170-24 Configuration Manual

ping

ping
Use this command to send ICMP echo‐request packets to another node on the network from the
switch CLI.
Syntax
ping host
Parameters
host
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to ping IP address 134.141.89.29. In this case, this host is alive:
C2(su)->ping 134.141.89.29
134.141.89.29 is alive
In this example, the host at IP address is not responding:
C2(su)->ping 134.141.89.255
no answer from 134.141.89.255

show users

Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
Syntax
show users
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to use the show users command. In this output, there are two Telnet
users logged in with Read‐Write access privileges from IP addresses 134.141.192.119 and
134.141.192.18:
14-14 Logging and Network Management
Specifies the IP address of the device to which the ping will be sent.