Clear Cos Port-Config - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear cos port-config

Mode
Switch command, read‐only.
Example
This example shows all inbound rate limiting port groups. Note that ports ge.1.1 through ge.1.48
were removed from the default port group 0.0 when they were added to port groups 1.0 and 2.0.
C2(su)->show cos port-config irl
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
Port Group Name
Port Group
Port Type
Assigned Ports
----------------------------------------------------------------------
clear cos port-config
Use this command to clear CoS port groups or assigned ports.
Syntax
clear cos port-config {irl|flood-ctrl} {all | group-type-index [entry] | [name]
[ports]}
Parameters
irl
flood‐ctrl
all
group‐type‐index
entry
name
ports
11-26 Policy Classification Configuration
:Default
:0
:0
:none
:Users
:1
:0
:ge.1.1-46
:Uplink
:2
:0
:ge.1.47-48
Clear an IRL port group configuration.
Clear a flood control port group configuration.
Clear all inbound rate limiting port‐config non‐default entries.
Delete a specific port group or group name, or clear the ports from that
group. Valid entries are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
Delete this non‐default inbound rate limiter entry.
Clear the administratively assigned textual description of this port group
entry to its default.
Clear the ports assigned to this group to its default.