Ip Igmp Last-Member-Query-Count; Ip Igmp Robustness - Enterasys SecureStack C2 C2G170-24 Configuration Manual

ip igmp last-member-query-count

Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP last member query interval to 10 seconds on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp last-member-query-interval 10
ip igmp last-member-query-count
Use this command to set the number of group‐specific queries sent before assuming there are no
local members. The no form of this command resets the IGMP last member query count to the
default value of 2.
Syntax
ip igmp last-member-query-count count
no ip igmp last-member-query-count
Parameters
count
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP last member query count to 10 on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp last-member-query-count 10

ip igmp robustness

Use this command to configure the robustness tuning for expected packet loss on an IGMP
routing interface. The no form of this command resets the IGMP robustness value to the default of
2.
Syntax
ip igmp robustness robustness
no ip igmp robustness
Parameters
robustness
13-16 IGMP Configuration
Specifies the number of IGMP startup queries. Valid values are from 1 to
20. The default value is 2.
Specifies the IGMP robustness value. Valid values are from 1 to 255. The
default value is 2.