Redistribute - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Mode
Router configuration: C2(su)‐>router(Config‐router)#
Usage
This command does not affect the sending of RIP updates on the specified interface.
Example
This example shows how to deny the reception of RIP updates on VLAN 2:
C2(su)->router(Config)#router rip
C2(su)->router(Config-router)#no receive-interface vlan 2

redistribute

Use this command to allow routing information discovered through non‐RIP protocols to be
distributed in RIP update messages. The no form of this command clears redistribution
parameters.
Syntax
redistribute {connected | ospf process-id | static} [metric metric value]
[subnets]
no redistribute {connected | ospf process-id | static}
Parameters
connected
ospf
process‐id
static
metric metric value
subnets
Mode
Router configuration: C2(su)‐>router(Config‐router)#
Defaults
If metric value is not specified, 1 will be applied.
If subnets is not specified, only non‐subnetted routes will be redistributed.
Specifies that non‐RIP routing information discovered via directly
connected interfaces will be redistributed.
Specifies that OSPF routing information will be redistributed in RIP.
Specifies the process ID, an internally used identification number for each
instance of the OSPF routing process run on a router. Valid values are 1 to
65535.
Specifies that non‐RIP routing information discovered via static routes will
be redistributed. Static routes are those created using the ip route
command detailed in "ip route" on page 19‐17.
(Optional) Specifies a metric for the connected, OSPF or static
redistribution route. This value should be consistent with the designation
protocol.
(Optional) Specifies that connected, OSPF or static routes that are
subnetted will be redistributed.
SecureStack C2 Configuration Guide 20-9
redistribute