Clear Port Priority - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Syntax
set port priority port-string priority
Parameters
port‐string
priority
Defaults
None.
Mode
Switch command, read‐write.
Usage
The set port priority command will not change the 802.1p priority tag on tagged traffic with a
default priority tag. The command only has an effect on how untagged traffic will be prioritized
as it passes internally through the device.
Example
This example shows how to set a default priority of 6 on ge.1.3. Frames received by this port
without priority information in their frame header are set to the default setting of 6:
C2(su)->set port priority

clear port priority

Use this command to reset the current CoS port priority setting to 0. This will cause all frames
received without a priority value in its header to be set to priority 0.
Syntax
clear port priority port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Specifies the port for which to set priority. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 7‐2.
Specifies a value of 0 to 7 to set the CoS priority for the port entered in the
port‐string. Priority value of 0 is the lowest priority.
ge.
1.3 6
Specifies the port for which to clear priority. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 7‐2.
clear port priority
SecureStack C2 Configuration Guide 12-3