Event Group Commands; Purpose; Commands; Show Rmon Event - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Event Group Commands

Purpose

To display and clear RMON events, and to configure RMON event properties.

Commands

For information about...

show rmon event

set rmon event properties
set rmon event status
clear rmon event
show rmon event
Use this command to display RMON event entry properties.
Syntax
show rmon event [index]
Parameters
index
Defaults
If index is not specified, information about all RMON entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON event entry 3:
C2(rw)->show rmon event 3
Index 3
----------------
Owner
Status
Description
Type
Community
Last Time Sent = 0 days 0 hours 0 minutes 37 seconds
Table 15‐3 provides an explanation of the command output.
(Optional) Displays RMON properties and log entries for a specific entry
index ID.
= Manager
= valid
= STP Topology change
= log-and-trap
= public
Event Group Commands
Refer to page...
15-13
15-14
15-15
15-15
SecureStack C2 Configuration Guide 15-13