Set Snmp User; Show Snmp User Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

If user is not specified, information about all SNMP users will be displayed.
If remote is not specified, user information about the local SNMP engine will be displayed.
If not specified, user information for all storage types will be displayed.
Mode
Switch command, read‐only.
Examples
This example shows how to display an SNMP user list:
C2(su)->show snmp user list
--- SNMP user information ---
--- List of registered users:
Guest
admin1
admin2
netops
This example shows how to display information for the SNMP "guest" user:
(su)->show snmp user guest
--- SNMP user information ---
EngineId:
Username
Auth protocol
Privacy protocol
Storage type
Row status
Table 8‐4 provides an explanation of the command output.
Table 8-4 show snmp user Output Details
Output Field
EngineId
Username
Auth protocol
Privacy protocol
Storage type
Row status

set snmp user

Use this command to create a new SNMPv3 user.
Syntax
set snmp user user [remote remoteid] [authentication {md5 | sha}] [authpassword]
[privacy privpassword] [volatile | nonvolatile]
00:00:00:63:00:00:00:a1:00:00:00:00
= Guest
= usmNoAuthProtocol
= usmNoPrivProtocol
= nonVolatile
= active
What It Displays...
SNMP local engine identifier.
SNMPv1 or v2 community name or SNMPv3 user name.
Type of authentication protocol applied to this user.
Whether a privacy protocol is applied when authentication protocol is in
use.
Whether entry is stored in volatile, nonvolatile or read-only memory.
Status of this entry: active, notInService, or notReady.
set snmp user
SecureStack C2 Configuration Guide 8-9