Enterasys SecureStack C2 C2G170-24 Configuration Manual page 512

clear arpinspection vlan
Defaults
If logging is enabled for the specified VLAN but logging is not entered with this command,
logging will remain enabled.
Mode
Switch command, read‐write.
Usage
You can use this command to disable dynamic ARP inspection on one or more VLANs, or you can
disable logging of invalid ARP packets on specified VLANs. To disable both logging and DAI, you
must enter this command twice.
Example
This example first displays the DAI configuration for VLAN 5, then disables DAI on VLAN 5, then
disables logging of invalid ARP packets on VLAN 5.
C2(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
C2(su)->clear arpinspection vlan 5
C2(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
C2(su)->clear arpinspection vlan 5 logging
C2(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
17-28 DHCP Snooping and Dynamic ARP Inspection
Configuration Log Invalid
------------- ----------- --------------------------------
Enabled Enabled
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Enabled
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Disabled
Disabled
Disabled
Disabled
ACL Name
staticARP
Disabled
Disabled
Disabled
ACL Name
staticARP
Disabled
Disabled
Disabled
ACL Name
staticARP
Static flag
-----------
Enabled
Static flag
-----------
Enabled
Static flag
-----------
Enabled