Ip Pimsm Enable - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Parameters
ipaddress
groupadress
groupmask
Defaults
None.
Mode
Global Router configuration: C2(su)‐>router(Config)#
Example
This example shows how to set an RP for a specific multicast group.
C2(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0

ip pimsm enable

This command sets the administrative mode of PIM‐SM multicast routing on a routing interface to
enabled. By default, PIM is disabled on all IP interfaces. The no form of this command disables
PIM on the specific interface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to enable PIM on IP interface for VLAN 1.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm enable
The IP address of the Rendezvous Point
The group address supported by the Rendezvous Point
The group mask for the group address
(su)‐>router(Config‐if(Vlan 1))#
ip pimsm enable
SecureStack C2 Configuration Guide 20-51