Table of Contents
Advertisement
At startup, the SecureStack C2 switch is configured with many defaults and standard features.
This chapter describes how to customize basic system settings to adapt to your work environment.
For information about...
Quick Start Setup Commands
Setting User Accounts and Passwords
Setting Basic Switch Properties
Downloading a Firmware Image
Reviewing and Selecting a Boot Firmware Image
Starting and Configuring Telnet
Managing Switch Configuration and Files
Clearing and Closing the CLI
Resetting the Switch
Using and Configuring WebView
Gathering Technical Support Information
Quick Start Setup Commands
The tables in this section provide a quick reference for the CLI commands needed to begin basic
C2 switch operation. Table
up the switch with the latest firmware. Table
perform additional basic configuration on the switch. Refer to the pages listed for more
information about each command.
Table 3-1 Required CLI Setup Commands
Step Task
1
Set a new password.
2
Set the switch IP address.
3
Download, activate, and verify new
firmware on the switch using TFTP
copy.
3‐1 lists tasks and their associated CLI commands required for setting
3‐2 lists optional CLI commands that will help you
CLI commands
set password [username]
set ip address ip-address [mask
ip-mask] [gateway ip-gateway]
copy tftp://tftp_server_ip_address/
filename system:image
set boot system filename
show version
Basic Configuration
Refer to page...
SecureStack C2 Configuration Guide 3-1
3
3-1
3-2
3-9
3-30
3-33
3-35
3-37
3-47
3-48
3-50
3-52
Refer to
page...
3-5
3-11
3-43
3-34
3-25
Advertisement
Table of Contents
