Clear Port Txq - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear port txq

Usage
Queues can be set for strict priority (SP) or weighted round‐robin (WRR). If set for WRR mode,
weights may be assigned to those queues with this command. Weights are specified in the range of
0 to 100 percent. Weights specified for queues 0 through 7 on any port must total 100 percent.
Examples
This example shows how to change the arbitration values for the eight transmit queues belonging
to ge.1.1:
C2(su)->set port txq
This example shows how to change the algorithm to strict priority for the eight transmit queues
belonging to ge.1.1:
C2(su)->set port txq
C2(su)->show port txq
Port
-----
ge.
1.1
clear port txq
Use this command to clear port transmit queue values back to their default values.
Syntax
clear port txq port-string
Parameters
port‐string
Defaults
By default, transmit queues are defined as follows:
Queue
0
1
2
3
Mode
Switch command, read‐write.
12-8 Port Priority and Rate Limiting Configuration
ge.
1.1 10 10 10 10 10 10 10 30
ge.
1.1 0 0 0 0 0 O O 100
ge.
1.1
Alg Q0 Q1 Q2 Q3
--- --- --- --- --- --- --- --- ---
STR SP SP SP SP
Clears transmit queue values on specific port(s) back to their default
values. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 7‐2.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
Mode
WRR
WRR
WRR
WRR
Q4 Q5 Q6 Q7
SP SP SP SP
Weight Queue
1 4
2 5
3 6
4 7
Mode Weight
WRR 5
WRR 6
WRR 7
WRR 8