Show Ip Pimsm Interface; Show Ip Pimsm Componenettable Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show ip pimsm interface

Component
Index
----------
1
Table 20‐8 provides an explanation of the command output.
Table 20-8 show ip pimsm componenettable Output Details
Output Field
Component Index
Component BSR
Address
Component BSR
Expiry Time
Component CRP
Hold Time
show ip pimsm interface
This command displays PIM‐SM status of the router interfaces. With the stats parameter, this
command displays statistical information for PIM‐SM on the specified interface.
Syntax
show ip pimsm interface {vlan vlan-id | stats {vlan-id | all}}
Parameters
vlan vlan‐id
stats
vlan‐id | all
Defaults
None.
Mode
Any router mode.
Examples
This example shows how to display PIM interface information.
.
C2(su)->router> show ip pimsm interface vlan 30
VLAN ID
IP Address
Subnet Mask
Mode
20-54 IPv4 Routing Protocol Configuration
COMPONENT TABLE
Component Component
BSR Address BSR Expiry Time CRP Hold Time
(hh:mm:ss)
--------------- --------------- -------------
192.168.30.2 00:02:10
What it displays
This field displays a number which uniquely identifies the component.
This field displays the IP address of the bootstrap router (BSR) for the local PIM
region.
This field displays the minimum time remaining before the BSR in the local domain
will be declared down.
This field displays the hold time of the component when it is a candidate rendezvous
point.
Display PIM‐SM information for the specified IP interface enabled for
PIM.
Display PIM‐SM interface statistics.
Display statistics for a specific VLAN or all VLANs.
30
192.168.30.1
255.255.255.0
enable
Component
(hh:mm:ss)
00:00:00