Clear Dhcpsnooping Limit - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Syntax
clear dhcpsnooping database [write-delay]
Parameters
write‐delay
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command will set the database write delay value to the default of 300 seconds.
Example
This example sets the database storage location to the default of local.
C2(su)->clear dhcpsnooping database

clear dhcpsnooping limit

Use this command to reset the rate limit values to the defaults of 15 packets per second with a
burst interval of 1 second.
Syntax
clear dhcpsnooping limit port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example resets the rate limit values to their defaults on port ge.1.1.
C2
(su)->clear dhcpsnooping limit ge.1.1
(Optional) Specifies that the write delay value should be returned to the
default value of 300 seconds.
Specifies the port or ports to which this command applies.
clear dhcpsnooping limit
SecureStack C2 Configuration Guide 17-15