Set Switch Movemanagement; Set Switch Member - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Mode
Switch command, read‐write.
Example
This example shows how to assign the name "FirstUnit" to switch unit 1 in the stack:
C2(su)->set switch description 1 FirstUnit

set switch movemanagement

Use this command to move management switch functionality from one switch to another.
Syntax
set switch movemanagement fromunit tounit
Parameters
fromunit
tounit
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to move management functionality from switch 1 to switch 2:
C2(su)->set switch movemenagement 1 2
Moving stack management will unconfigure entire stack including all interfaces.
Are you sure you want to move stack management? (y/n) y

set switch member

Use this command to add a virtual member to a stack. This allows you to preconfigure a switch
before the physical device is actually added to the stack.
Syntax
set switch member unit switch-id
Parameters
unit
switch‐id
Defaults
None.
Specifies the unit number of the current management switch.
Specifies the unit number of the newly‐designated management switch.
Specifies a unit number for the switch.
Specifies a switch ID (SID) for the switch. SIDs can be displayed with the
show switch switchtype command.
set switch movemanagement
SecureStack C2 Configuration Guide 2-11