Show Spantree Lptrapenable; Clear Spantree Lptrapenable - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show spantree lptrapenable

Defaults
None.
Mode
Switch command, read‐write.
Usage
Loop Protect traps are sent when a Loop Protect event occurs, that is, when a port goes to listening
due to not receiving BPDUs. The trap indicates port, SID and loop protection status.
Example
This example shows how to enable sending of Loop Protect traps:
C2(rw)->set spantree lptrapenable enable
show spantree lptrapenable
Use this command to display the current status of Loop Protect event notification.
Syntax
show spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current Loop Protect event notification status:
C2(rw)->show spantree lptrapenable
The Loop Protect event notification status is enable

clear spantree lptrapenable

Use this command to return the Loop Protect event notification state to its default state of
disabled.
Syntax
clear spantree lptrapenable
Parameters
None.
9-50 Spanning Tree Configuration