Clear Nodealias Config - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Itʹs important to make sure that inter‐switch links are not learning node/alias information, as it
would slow down searches by the NetSight Compass and ASM tools and give inaccurate results.
Example
This example shows how to disable the node alias agent on ge.1.3:
C2(su)->set nodealias disable ge.1.3

clear nodealias config

Use this command to reset node alias state to enabled and clear the maximum entries value.
Syntax
clear nodealias config port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the node alias configuration on ge.1.3
C2(su)->clear nodealias config ge.1.3
Specifies the port(s) on which to reset the node alias configuration.
clear nodealias config
:
SecureStack C2 Configuration Guide 14-37