Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example returns port
C2(rw)->clear lldp port med-trap ge.1.1
clear lldp port tx-tlv
Use this command to clear the optional LLDP and LLDP‐MED TLVs to be transmitted in
LLDPDUs by the specified port or ports to the default value of disabled.
Syntax
clear lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-loc] [med-poe]} port-string
Parameters
all
port‐desc
sys‐name
sys‐desc
sys‐cap
mgmt‐addr
vlan‐id
stp
lacp
gvrp
mac‐phy
Specifies the port or range of ports to be affected.
1.1 to the default LLDP‐MED trap state of disabled.
ge.
Disables all optional TLVs from being transmitted in LLDPDUs.
Disables the Port Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Name optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Capabilities optional basic LLDP TLV from
being transmitted in LLDPDUs.
Disables the Management Address optional basic LLDP TLV from
being transmitted in LLDPDUs.
Disables the Port VLAN ID IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
Disables the Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the MAC‐PHY Configuration/Status IEEE 802.3 Extensions
TLV from being transmitted in LLDPDUs.
clear lldp port tx-tlv
SecureStack C2 Configuration Guide 6-29