Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP configuration information.
C2(ro)->show lldp
Message Tx Interval
Message Tx Hold Multiplier : 4
Notification Tx Interval
MED Fast Start Count
Tx-Enabled Ports
Rx-Enabled Ports
Trap-Enabled Ports
MED Trap-Enabled Ports
show lldp port status
Use this command to display the LLDP status of one or more ports. The command lists the ports
that are enabled to send and receive LLDP PDUs. Ports are enabled or disabled with the set lldp
port status command.
Syntax
show lldp port status [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, LLDP status information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP port status information for all ports.
C2(ro)->show lldp port status
: 30
: 5
: 3
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
(Optional) Displays LLDP status for one or a range of ports.
show lldp port status
SecureStack C2 Configuration Guide 6-15