Table of Contents
Advertisement
Table 19-1 show ip interface Output Details (Continued)
Output Field
Outgoing Access
List
MTU
ARP Timeout
Direct Broadcast
Proxy Arp
ip address
Use this command to set, remove, or disable a primary or secondary IP address for an interface.
The no form of this command removes the specified IP address and disables the interface for IP
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
Parameters
ip‐address
ip‐mask
secondary
Defaults
If secondary is not specified, the configured address will be the primary address for the interface.
Mode
Router interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Usage
Each SecureStack C2 system supports up to 24 routing interfaces, with up to 8 secondary
addresses allowed for each primary IP address.
Example
This example sets the IP address to 192.168.1.1 and the network mask to 255.255.255.0 for VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip address 192.168.1.1 255.255.255.0
What It Displays...
Not supported.
Interface's Maximum Transmission Unit size.
Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in
Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in
"ip
Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in
Specifies the IP address of the interface to be added or removed.
Specifies the mask for the associated IP subnet.
(Optional) Specifies that the configured IP address is a secondary address.
"arp
timeout" on page 19-11.
directed-broadcast" on page 19-12.
"ip
proxy-arp" on page 19-10.
SecureStack C2 Configuration Guide 19-5
ip address
Advertisement
Table of Contents
