Western Digital Ultrastar Serv60+8 User Manual page 49

User Guide
1. Locate the release clips on the rear and press them inward to release the clamp.
Figure 29: Clamp Release (clamp shown in blue for visual clarity)
2. Slide the clamp in the direction shown in the following image to loosen it from the drive. Be sure not to
slide too far as this will allow the clamp to fall from from the carrier body and it will have to be reinstalled.
Figure 30: Clamp Slide (clamp shown in blue for visual clarity)
3. Insert the 2.5" drive into the drive slot so that it is snug into the corner.
49
3 Component Overviews
3.7 Drive Assembly Description