Western Digital Ultrastar Serv60+8 User Manual page 177

User Guide
b) Open all of the baskets
Figure 214: Open Baskets
c) Route all of the cables being connected to the enclosure through the open baskets.
d) Close all of the baskets.
e) If the Ultrastar Serv60+8 is being installed in a rack and will subsequently be transported inside that
rack, it is important to use the included cable tie to wrap the CMA bundle to ensure it does not get
damaged during transport. If the Ultrastar Serv60+8 is instead being installed where it will operated,
skip this step. Remember to remove the cable ties after the enclosure has reached its final operational
location.
f) Reconnect the CMA at the elbow to the connectors on the rail.
22. Test for binding in the extension of the CMA by gently pulling the enclosure out of the rack to ensure the
cables extend properly and that the system doesn't bind at all. If it does, examine the point at which the
binding occurred and adjust the seating of cables in the baskets, check the connections to the rails, and
examine the joints of the CMA arm to ensure that they are all functioning properly.
23. Make sure the CMA is in operational position by folding the arm in toward the enclosure and attaching
the elbow end of the CMA to the connector that is attached to the rail. Verify that all of the cabling is in
functional order and does not bind or catch.
177
4 Part Replacement
4.10 M.2 Replacement