Western Digital Ultrastar Serv60+8 User Manual page 211

User Guide
a) From the front of the rack, locate the release clip as shown in the following image.
Figure 263: Front Rail Release Clip Operation
Unlatch He re
b) Press the release clip and press lightly toward the rear of the rack to compress the rail clear of the
rack post.
c) Let go of the rail and move to the rear of the rack.
d) Support the rail with one hand and press the release button with the other to free the rail from the rack
and remove it.
Figure 264: Rear Rail Latch Release Button
16. Gather the replacement rails and prepare to install them.
17. Remove the inner rail that is nested inside the rack rails.
Note: There are Right and Left rails and they must be installed as a set. Each inner rail will read
"R" for the right or "L" for the left embossed on the inside. Each outer rail will read "R-Front" for
the right or "L-Front" for the left. Right and Left refer to when you are facing the front of the rack.
a) Start by sliding the inner rail out of the outer/rack rail until the safety latch engages and the inner rail
will not extend further. It will only slide one way.
211
4 Part Replacement
4.13 Rails Replacement