Western Digital Ultrastar Serv60+8 User Manual page 220

User Guide
23. Secure the chassis top cover to the rack using the included washers, the M5 x 12mm Phillips Pan Head
screws, and a Philips screwdriver as shown in the following image. These screws should be tightened
to 3.38-3.61 Nm / 30-32 in-lbf using a # 2 Philips Screwdriver.
Figure 277: Cover Retention Screws
Note: If any drives were removed earlier to facilitate the removal of the chassis, follow the rest of the
steps to reinstall the drives by following the labeling scheme noted earlier. If not, proceed to the cabling
section.
24. If the chassis is being installed into a rack that will be shipped fully assembled, you must install eight
(four per side) of the included M5 x 10mm T15 Torx screws into the two brackets at the front of the chassis
in the following locations. These screws should be tightened to 3.38-3.61 Nm / 30-32 in-lbf using a Long
220
4 Part Replacement
4.13 Rails Replacement