Western Digital Ultrastar Serv60+8 User Manual page 266

User Guide
c) Slowly slide the enclosure forward to ensure the CMA arm is operating properly, then slide it back
into the rack.
52. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out
of the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from
coming out of the rack completely and the cover will remain in the rack attached to the rear alignment
brackets.
Figure 348: Chassis Handle Operation
53. Install the IOM.
a)
Caution:
to be replaced. For this reason it is imperative that the IOM is not forced into position, that it is
inserted straight, and that the directions for installing the IOM are followed exactly.
b) Ensure that the handles on the IOM are not latched. To unlatch them, press the latch release in the
direction shown in the following image.
Figure 349: Unlatching IOM Handles
c) Align the IOM with the empty slot on the top of the chassis so that the arrow on the IOM latch release
is facing toward the side shown in the following image.
If a pin on the IOM's internal connectors is bent or damaged, the IOM will have
266
4 Part Replacement
4.14 Chassis Replacement