Western Digital Ultrastar Serv60+8 User Manual page 316

User Guide
2. The Security settings default to a standard set of settings. If the standard settings are sufficient, exit the
Security Settings section. If a new or updated settings are preferred, complete the information as shown
in section below:
a) Default IP Blocking Settings:
Figure 414: IP Blocking Settings
• IP Blocking: The checkbox is selected by default. Uncheck Enable to disable the IP Block Settings.
• Failed Login Attempts: The value of 3 failed login attempts set by default. The user has to have three
failed attempts before being locked out. On the fourth failed attempt the user will be locked out. Input a
different number to change the amount of failed attempts that are aloud before the user is locked out.
• Failed Login Interval Time (sec): The value of 20 seconds between failed login attempts is set by default.
Input a different number of seconds to change the amount of time between being locked out due to failed
login attempts. The number of failed login attempts is defined by the Failed Login Attempts field.
• Remote Client Lockout Time (sec): The value of 120 seconds of remote client lockout time is set by
default. If the user exceeds the number of failed login attempts, it will lock remote access to the BMC Web
GUI for the defined amount of time. Input a different number of seconds to change the amount of time
between being locked out due to failed login attempts.
b) Default Port Settings:
Figure 415: Port Settings
• HTTPS (Secure) Port The port settings are set to a default of 443. Input a different number to change the
specific port that is being connected.
c) Default Optional Network Services:
Figure 416: Optional Network Services
• SMASH SSH: The checkbox is selected by default. Uncheck Enable to disable SMASH SSH.
• SOL SSH: The checkbox is not selected by default. Check Enable to enable SOL SSH.
316
5 System Management
5.3 HGST BMC Web GUI