Western Digital Ultrastar Serv60+8 User Manual page 215

User Guide
h) Follow these steps for the other outer rail.
20. Install the rear cover alignment brackets.
a) From the rear of the rack, orient the alignment brackets so that the groove that will catch the cover is
facing the inside of the rack.
Figure 270: Alignment Bracket Groove (highlighted in red)
b) Use five of the M5 x 10mm T15 Torx screws and five of the included washers and attach the rear
cover alignment bracket to the vertical rail with the Long T15 Torx Screwdriver. Add three M5 x 10mm
T15 Torx screws and three included washers to attach the rear rail (the three lower holes) to the rack
posts as shown in the following image. These screws should be tightened to 3.38-3.61 Nm / 30-32
in-lbf using a Long T15 Torx Screwdriver.
Figure 271: Screw and Washer Order
215
4 Part Replacement
4.13 Rails Replacement