Western Digital Ultrastar Serv60+8 User Manual page 319

User Guide
2. Enable and configure the IPv4 Network Settings by completing the following steps:
Note: No changes are needed to this section if DHCP is the preferred method. The BMC Web GUI
is set to DHCP by default.
Figure 420: IPv4 Network Settings — Enabled
a) Hostname: The hostname is autogenerated by default. To change the defaulted hostname, type a new
hostname into the field.
b) Enable LAN Failover: The Enable LAN Failover is defaulted to disbaled. Select the checkbox to enable
this feature.
c) LAN Channel: The LAN Channel option defaults to Channel-3. Choose another option from the
drop-down list to change the value.
d) MAC Address: The MAC Address is autogenerated.
e) NIC Description: Defaulted to Dedicated to BMC Web GUI with no option to change the value.
f) Link Status: The Link Status defaults to Obtain an IP address automatically (use DHCP). This
configures the IPv4 network settings to use DHCP for the IP Address, Subnet Mask, Gateway, Primary
DNS Sever, and Secondary DNS Server. The other options allow for the user to choose a specific IP
Address or to disable the IPv4 Network altogether.
g) IP Address: The IP Address is obtained by DHCP by default. Select the option Use the following IP
address to enter a specific IP Address into the field next to IP address.
h) Subnet Mask: The Subnet Mask is obtained by DHCP by default. The Use the following IP address
option must be selected to input a specific subnet mask.
i) Gateway: The Gateway is obtained by DHCP by default. The Use the following IP address option
must be selected to input a specific gateway.
j) Primary DNS Server: The Primary DNS Server is obtained by DHCP by default. The Use the following
IP address option must be selected to input the primary DNS server.
k) Secondary DNS Server: The Secondary DNS Server is obtained by DHCP by default. The Use the
following IP address option must be selected to input the secondary DNS server.
319
5 System Management
5.3 HGST BMC Web GUI