Western Digital Ultrastar Serv60+8 User Manual page 322

User Guide
2. Enable and configure the IPv6 Network Settings by completing the following steps:
Figure 423: IPv6 Network Settings — Enabled
a) Enable LAN Failover: The Enable LAN Failover is defaulted to disbaled. Select the checkbox to enable
this feature.
b) LAN Channel: The LAN Channel option defaults to Channel-3. Choose another option from the
drop-down list to change the value.
c) MAC Address: The MAC Address is autogenerated.
d) NIC Description: Defaulted to Dedicated to BMC Web GUI with no option to change the value.
e) Link Status: The Link Status defaults to Disable. This configures the IPv6 network settings to disabled.
Select another option to enable the link status. The user may select the option to enable DHCP or to
use a specific IP Address.
f) IP Address: The IP Address is uneditable by default. Select the option Use the following IP address
to enter a specific IP Address into the field next to IP address.
g) Prefix Length: The IPv6 Prefix Length is uneditable by default. Select the option Use the following
IP address to enter a specific Prefix Length into the field.
Note: The Prefix Length is used to identify how many bits of a Gobal Unicast IPv6 Address are
available in the network.
h) Gateway: The Gateway is uneditable by default. The Use the following IP address option must be
selected to input a specific gateway.
i) Primary DNS Server: The Primary DNS Server is uneditable by default. The Use the following IP
address option must be selected to input the primary DNS server.
j) Secondary DNS Server: The Secondary DNS Server is uneditable by default. The Use the following
IP address option must be selected to input the secondary DNS server.
3. Save the new settings.
A message notifying that the parameters of the IPv6 Network Settings section have been set will appear.
322
5 System Management
5.3 HGST BMC Web GUI