Western Digital Ultrastar Serv60+8 User Manual page 265

User Guide
49. Secure the chassis top cover to the rack using the included washers, the M5 x 12mm Phillips Pan Head
screws, and a Philips screwdriver as shown in the following image. These screws should be tightened
to 3.38-3.61 Nm / 30-32 in-lbf using a # 2 Philips Screwdriver.
Figure 346: Cover Retention Screws
50. Now that the chassis is installed, test the installation by sliding the enclosure in and out of the rack a
minimum of three times. If the enclosure binds, catches, or displays any incorrect motion or behavior
retry the installation.
Note: Adjustments of the vertical rack rails may be required to fix any issues that may
occur.
51. Install the CMA.
a) Orient the CMA so that the elbow is on the left hand side.
b) Attach all of the connectors to the brackets on the rails and chassis. There should be one at the elbow
side and two at the other end.
Figure 347: CMA Orientation
265
4 Part Replacement
4.14 Chassis Replacement