Western Digital Ultrastar Serv60+8 User Manual page 267

User Guide
d) Slowly lower the IOM into the empty slot while being careful to keep it level. Do not to force it.
Figure 350: Installing the IOM
e) When the IOM is lowered fully, apply light pressure with both hands evenly on the IOM body, not the
handles, to seat the IOM in the connector. If the IOM won't seat correctly, DO NOT FORCE IT. Instead,
back the IOM out, check the pins to make sure none are damaged, and try again.
f) Once the IOM is seated properly in the slot, close the handles until they latch closed.
54. Install the drive blank in slot B using the same method as installing the IOM.
55. Install the System SSD.
a) Lift the center channel flap and orient the assembly so that the latch release button is facing toward
the rear of the system.
Figure 351: Lift the Center Channel Flap
267
4 Part Replacement
4.14 Chassis Replacement